Filter
Top Products
16 U35 FPI Direct Vent Gas Insert
FULL SCREEN DOORS
INSTALLATION
1) Hold the full screen faceplate up against the unit in order to make
the following wire connections.
Pull the ON/OFF connector wires thru the box and connect them to
the switch.
Connect the fan switch wires with the wire connectors from the fan
speed control. Place clips over wires and tuck into side trim.
2) Lift the unit up slightly and push down on the corners of the Bottom
Trim Bracket and slide under unit.
3) Completely secure faceplate to the unit by securing 4 screws to the
Left and Right Side Trim.
Bottom Trim
Bracket
Push in Corners
4) Secure the Top Frame by sliding it on the screws at the top of the
full screen door. It is held in place by magnets.
Top Frame
Screw