Regency I1100S Indoor Fireplace User Manual


 
Regency Wood Insert & Hearth Heater 11
BRICK FLUE BAFFLE &
SECONDARY AIR TUBE
INSTALLATION
The fl ue baffl e system located in the upper area
of the fi rebox is removable to make cleaning
your chimney system easier. The brick baffl es
must be installed prior to your fi rst fi re. Smoke
spillage and draft problems may occur if the
baffl es are improperly positioned. Check the
position of the brick baffl es on a regular basis as
they can be dislodged if too much fuel is forced
into the fi rebox.
The Large Insert I3100L is shipped with two of
the secondary air tubes loose inside the fi rebox.
They need to be installed after the brick baffl e
are installed. Follow the directions below.
Large Insert I3100L
The unit arrives with the fi rst two air tubes (from
the front) and the 2 baffl e bricks on the fl oor of
the fi rebox. The baffl e bricks are positioned fi rst
and then the air tubes are installed.
NOTE: If the fi rst 2 airtubes are already
installed in the stove, they must be
removed in order to install the Brick
Baffl es.
1) Slide the left baffl e brick over the two rear
air tubes and then push it all the way to the
left side of the fi rebox.
Front View
Large Insert (I3100L)
Small Insert (I1100S)
Hearth Heater (H2100M)
2) Tilt the fi rst Baffl e Brick down and then slide
the 2nd Baffl e Brick up and back. Reposition
both baffl e bricks fl at on the air tubes.
3) Important: push both baffl e bricks so
they are tight against the side walls.
4) Install the two front air tubes into the holes
on the side channels. The notch goes on
the right hand side with the air holes facing
forward toward the door opening. If the tube
will not slide in easily, simply use a pair of
vise grips or pliers and tap it into place with
a hammer. A tighter fi t will ensure the tube
will not move when the unit is burning.
INSTALLATION
FLOOR PROTECTION
Please check to ensure that your fl oor protection
and hearth will meet the standards for clearance
to combustibles. Your hearth extension must be
made from a non-combustible material.
FIREBRICK ASSEMBLY
Firebrick is included to extend the life of your
insert and radiate heat more evenly. Check to
see that all fi rebricks are in their correct posi-
tions and have not become misaligned during
shipping.
DOOR HANDLE
Attach spring handle by rotating counter clock-
wise onto rod. Ensure that the rod fi ts into the
entire length of the spring handle.
Note: When cleaning the chimney reverse
the above procedures, removing
the air tube and baffl e bricks and
then replace them when cleaning is
completed.