Filter
Top Products
Regency Freestanding Woodstove
16
INSTALLATION
Side View
Front View
Front View
Side View
Front View
Front View
3) Tilt the left baffle brick up on top of the side
channel and it will leave enough room to
position the right baffle brick in the same
manner as Step 1) above. Then reposition
the left baffle brick flat on the air tube.
manner as Step 1) above. Then reposition
the left baffle brick flat on the air tubes.
4) Install the two front air tubes into the holes
on the side channels. The notch goes on
the right hand side with the air holes facing
forward toward the door opening. If the
tube will not slide in easily, simply use a pair
of vise grips or pliers and tap it into place
with a hammer. A tighter fit will ensure the
tube will not move when the unit is burning.
Note: When cleaning the chimney re-
verse the above procedures, re-
moving the air tube and baffle
bricks and then replace them when
cleaning is completed.
Medium Stoves
F2100M and S2100M
The unit arrives with the 2 baffle bricks on the
floor of the firebox.
1) If all 3 air tubes are installed continue on to
Step 2), if not, follow the instructions be-
low. Install the air tube into the holes in the
side channels. The notch goes on the right
hand side with the air holes facing toward
the door. Slide the tube into the left hand
side, as far as possible and then bring it
back into the hole on the right hand side until
it locks into position. If the tube will not slide
in easily, simply use a pair of vise grips or
pliers and tap it into place with a hammer. A
tighter fit will ensure the tube will not move
when the unit is burning. See the diagram
for the large air tube installation (page 15),
though there are only three air tubes in the
medium units.
2) Slide the left baffle brick over the air tubes
from the front and then push it to the back.
4) Important: push both baffle bricks so
they are tight against the side walls.
Note: When getting the chimney cleaned,
push the brick baffles forward
toward the front of the stove, this
should leave sufficient access to
the flue. If it is not enough space
then remove the middle air tube
(reverse the procedure in step 1)
above), and baffle bricks and then
replace everything when cleaning
is completed.
Small Stoves F1100S
1) If the two air tubes are installed continue on
to Step 2), if not, follow the instructions
below. Install the air tube into the holes in the
side channels. The notch goes on the right
hand side with the air holes facing toward
the door. Slide the tube into the left hand
side, as far as possible and then bring it
back into the hole on the right hand side until
it locks into position. If the tube will not slide
in easily simply use a pair of vise grips or
pliers and tap it into place with a hammer. A
tighter fit will ensure the tube will not move
when the unit is burning. See the diagram
for the large air tube installation (page 15),
though there are only two air tubes in the
small units.
2) Slide the left baffle brick over the front air
tube and then slide it back over the rear air
tube.
3) Tilt the left baffle brick up on top of the side
channel and it will leave enough room to
position the right baffle brick in the same
4) Important: push both baffle bricks so
they are tight against the side walls.
Note: When getting the chimney cleaned,
remove the baffle bricks for ac-
cess to the flue, then replace them
when cleaning is completed.