Filter
Top Products
12
HOW TO USE YOUR EXPRESSIONS 500S SHOWER (SUMMARY)
Full details of terms and conditions are available on request from:-
APPLIED ENERGY PRODUCTS LIMITED
MORLEY WAY, PETERBOROUGH PE2 9JJ
TEL: +44 (0) 1733 456789
FAX: +44 (0) 1733 310606
Website: www.redring.co.uk
1. Ensure the electricity and water are turned on to the unit.
2. Press the start / stop button “B”.
This will turn the shower on, the water will flow and the
indicator lights will glow showing chosen Power Selection.
3. Knob “A” controls the power selection.
Select “High”, “Med (medium)” or “Cold”
4. If the water is not at your desired showering
temperature, turn knob “C” a small amount until you
reach the desired showering temperature.
Turn clockwise (follow blue arrows) for cooler.
Turn anti-clockwise (follow red arrows) for warmer.
As a helpful guide the kno
b position is indicated by a number being displayed in Window “D”.
On the scale “1” is the coolest, whilst “9” is the hottest.
5. When you have finished showering, press the start / stop button “B” again.
6. Water will continue to flow for up to 7 seconds before switching off.
This reduces the temperature of the water in the tank for the next user.
The indicator lights will go out.
7. Switch off the electricity supply at the ceiling switch or local isolator.
Notes
• Wait 20 seconds for the temperature to stabilise after each adjustment.
• The indicator lights illuminate when the heaters are on and, if the shower has been
recently used, can take up to 20 seconds to come on
.
During this time the water may go from very hot to cold before stabilising.
• The position of knob “C” will be approximately the same each time the shower is
used, varying only with incoming water temperature or pressure changes
(e.g. you will only need to change from summer to winter).