Filter
Top Products
6
Need Help? Call 1-800-598-2527
INSTALLATION ORDER
You can install your system in just
four easy steps:
1. Connect the system to power.
2. Train the remote controls.
3. Mount the system.
4. Install the status indicator.
CONNECTING THE
SYSTEM TO POWER
Warning:
We recommend that you
muffle the alarm’s speaker before you
connect the system to power. The
alarm is extremely loud.
Follow these steps to connect the
system to power.
1. Connect the system’s red lead to
your vehicle battery’s positive (+)
terminal.
2. Connect the system’s black lead
to a metal part of the vehicle’s
body that is not insulated from the
main chassis by any plastic part
or to the battery’s negative (–)
terminal. The system beeps three
times.
ACTIVATING THE
REMOTE CONTROLS
You must train the system to respond
to the supplied remote controls. To
activate both remote controls, imme-
diately after applying power, press
DISARM
on one of the remotes. The
system beeps twice.
If the system loses power, it stops re-
sponding to both remotes. Simply
press
DISARM
on one of the remotes
after power is restored to reactivate
them.
Both of the supplied system remotes
share the same remote code, but
your system can learn two remote
codes if you want to add another re-
mote control (RadioShack Cat. No.
49-845). To activate a second remote
control code, be sure the system is
disarmed, then hold down
ARM
for 10
seconds. The system beeps three
times. Press any button on the new
remote to activate it.
49-820.fm Page 6 Thursday, August 19, 1999 10:29 AM