Quadra-Fire SAPPHIRE-D-MBK Stove User Manual


 
23Quadra-Fire • Sapphire • 7055-116 Rev. D • 6/11
6
Gas Information
A. Fuel Conversions
Before making gas connections ensure that the appliance
being installed is compatible with the available gas type.
Any natural or propane gas conversions necessary to meet
the appliance and locality needs must be made by a quali-
ed technician using Hearth & Home Technologies speci ed
and approved parts.
1. Converting to LP Gas
Millivolt Generator
Thermocouple
Pilot Hood
Alignment Notch
Kit Contents: Replacement ori ce; replacement pilot injector;
valve regulator; conversion label.
Tools Required: #2 Phillips screwdriver, slotted screwdriver or
Torx TH20, 5/32 Allen wrench, 3/32 Allen wrench and 5/8 in.
open end wrench.
Figure 6.1 Remove cast front, glass, and logs. Remove
the two side bricks. Using a #2 Phillips Head screwdriver,
remove the two screws, one on
each side of burner. Retain
fasteners for re-installation. Lift burner up and out of the re-
box.
Figure 6.2 Pull off the pilot hood and set it aside.
Figure 6.4 Remove the main burner ori ce using a 5/8 in.
wrench. Replace ori ce with the proper size as indicated
for your gas type and venting.
• Re-install burner by placing it into the rebox. Secure in
place with the two screws previously removed. DO NOT
OVER TIGHTEN.
Re-install the two side bricks and attach with brick clips.
Re-install logs, glass and cast front.
NOTE: Gas conversions should only be performed by a
qualified service person, and/or where required by state
and local codes, licensed installer/service technician. In
the Commonwealth of Massachusetts, installation must
be performed by a licensed plumber or gas fitter.
NOTE: Do not remove the retaining clip from the hood.
5/32 Allen Wrench
Pilot Injector
5/8 Wrench
Orifice
Installation Propane (LP) Natural Gas
Top Vent .063 .106
Rear Vent .059 .098
Figure 6.3 Use a 5/32 Allen wrench to remove the pilot injec-
tor. Replace pilot injector with the one supplied with the
appliance (#35 for Propane, #62 for Natural Gas). There
is an alignment notch on the pilot hood. Replace the pilot
hood, snapping into position.
Remove 2 Screws