Quadra-Fire QVI35S Furnace User Manual


 
29
Quadra-Fire • QVI30S, QVI35S • 340-901 Rev. i • 6/09
B. Lighting Appliance
Standing Pilot Ignition
1. Turn off all electric power to the appliance if
service is to be performed.
2. Open control access panel.
3. Move switch to “OFF” position.
4. Push in gas control knob slightly and turn clock-
wise to OFF”. Do not force.
5. Close control access panel.
5. Turn knob on gas control counter clockwise
to “PILOT”.
6. Push in control knob all the way and hold in. Im-
mediately depress red or black piezo button. It may
require several depressions of the red or black
piezo button until PILOT lights. If PILOT light does
not light after 10 seconds, return to step 3. Continue to
hold the control knob in for about one minute after the
pilot is lit. Release knob and it will pop back out. Pilot
should remain lit. If it goes out, repeat steps 3 through 6.
If knob does not pop up when released, stop and im-
mediately call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your service
technician or gas supplier.
7. Turn gas control knob counterclockwise to
“ON”.
8. To light Burner, ip the on/off switch to the “ON”
position, and close access grille.
9. Turn on all electric power to the appliance.
1. Turn off all electric power to the appliance.
2. Push in gas control knob
slightly and turn clockwise
to “OFF”.
NOTE: Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
3. Wait ve (5) minutes to clear out any gas.
Then smell for gas, including near the oor. If you
smell gas, STOP! Follow “B” in the Safety Informa-
tion located on the left side of this label. If you don’t
smell gas, go to next step.
4. Find the pilot. The pilot is inside
combustion chamber next to the
main burner.
LIGHTING
INSTRUCTIONS
TO TURN OFF
GAS TO APPLIANCE
FOR YOUR SAFETY
READ BEFORE LIGHTING
DO NOT CONNECT 110 VAC TO
THE CONTROL VALVE.
Improper installation, adjustment, al-
teration, service or maintenance can
cause injury or property damage. Re-
fer to the owner’s information manual
provided with this appliance.
This appliance needs fresh air for
safe operation and must be installed
so there are provisions for adequate
combustion and ventilation air.
If not installed, operated, and main-
tained in accordance with the man-
ufacturer’s instructions, this product
could expose you to substances in fuel
or fuel combustion which are known to
the State of California to cause can-
cer, birth defects, or other reproduc-
tive harm.
Keep burner and control compartment
clean. See installation and operating
instructions accompanying appliance.
CAUTION:
Hot while in operation. Do not touch.
Keep children, clothing, furniture, gaso-
line and other liquids having ammable
vapors away.
Do not operate the appliance with
panel(s) removed, cracked or broken.
Replacement of the panel(s) should be
done by a licensed or quali ed service
person.
NOT FOR USE
WITH SOLID FUEL
For use with natural gas and propane.
A conversion kit, as supplied by the
manufacturer, shall be used to convert
this appliance to the alternate fuel.
Also Certi ed for Installation in a
Bedroom or a Bedsitting Room.
For assistance or additional informa-
tion, consult a quali ed installer, ser-
vice agency or the gas supplier.
WARNING:
464-903G
A. This appliance has a pilot which
must be lighted by hand. When
lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING, smell all
around the appliance area for gas.
Be sure to smell next to the oor
because some gas is heavier than
air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch;
do not use any phone in your
building.
Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
• If you cannot reach your gas sup-
plier, call the re department.
C. Use only your hand to push in or
turn the gas control knob. Never
use tools. If the knob will not push
in or turn by hand, don’t try to
repair it, call a quali ed service
technician. Force or attempted
repair may result in a re or explo-
sion.
D. Do not use this appliance if any
part has been under water. Im-
mediately call a quali ed service
technician to inspect the appliance
and to replace any part of the
control system and any gas control
which has been under water.
For additional information on operating your
Hearth & Home Technologies replace, please refer to www. replaces.com.
WARNING: If you do not follow these instructions
exactly, a re or explosion may result causing property
damage, personal injury or loss of life.