Filter
Top Products
August 1, 2008
Page 31Quadra-Fire · Garnet-T · 7016-127F
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Leg Leveling System
Figure 8.1 Thread Allen bolts through nuts until fl ush. The
Allen bolts and nuts are included in the component pack inside
the appliance fi rebox.
Figure 8.2 Slide assembled nuts and bolts into the slots on
the legs with the nuts on the bottom.
Figure 8.3 Use a 5/32 in. 4mm) Allen wrench to adjust legs
up and down to desired level.
C. Flue Restrictor Installation
Figure 8.4 Installation of the fl ue restrictor requires the
removal of the baffl e located inside the fi rebox. Remove the
baffl e by fi rst removing the two screws holding the baffl e in
place (one on each side). Lift the baffl e out of the bracket
along the back of the fi rebox, angle the baffl e slightly and
remove it from the fi rebox.
Figure 8.5 With the baffl e removed, remove the two screws
located in the back of the fi rebox. Reuse the screws to install
the fl ue restrictor.
When your installation falls within a shaded area on the
vent graph (page 11) a À ue restrictor must be installed
for proper operation.