R
R
R
October 11,, 2005
250-6422D
Page 33
Castile Pellet Stove
G. Glass Replacement
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury
WARNING
a. Open the face and remove door from the appliance
by lifting door off of hinge pin and lay on a flat surface
face down.
b. Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the
rod will slide up. Swing the rod toward you from the
bottom and remove the rod. Repeat for other side.
c. Remove old glass and replace with new glass.
d. Slide the retainer rod into the top hole first, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be paralle with the glass
in order to insert it into place. Figure 33.1.
Glass
Rope Retainer
Rods
Crimped end
at the bottom
Crimped end must be
parallel with the glass
Slide top
end in first
Figure 33.1