Filter
Top Products
-6-
-3-
Choose fitting position on the desk.
The thinkness of the table should be smaller than 55mm
Base
.
Choose the position that the Base you want installed.
Important: Make sure there is enough space to spread display, considering
the show size.
Step1
Step2 Attach
Choose fitting position on the desk.Step1
Step2
Attach Base
.
Step 6 Using Cable Management
The mount include a cable management function, where cables can be
routed along the length of the arm assembly.
To install cables, you’ll first need to remove the cable covers and set all
parts aside.
Step 6 Using Cable Management
Cable cover
Fig 5
Route the cables along one side of the Inner Arm (nearest the wall plate).
With cables in place, loosely secure the Inner Arm cable covers back in place.
Next, route the cables along the opposite side of the Outer Arm. Be sure to
leave slack in the cable where it transitions between two sides of the Arm
Assembly. With cables in position, loosely secure the Outer Arm cable
covers back in place.
For best system performance, route the AC power cable separately
from the signal cables.
With all cables in place, pull the display in and out and check that the
arm assembly moves freely, without stretching or damaging the cables,
andthensecurethecablecovers.
DO NOT use a hex wrench on the cable covers, only apply
pressure with your finger.
Note:
Important:
Note:
Important:
WARNING
We are not responsible for any personal injury or
product damage due to mishandling, incorrect
mounting, incorrect assembly or incorrect use of
this product.
Fig 1
Fig 6