Procom SSU320RHL-B Stove User Manual


 
7
INSTALLATION
CHECK GAS TYPE
Be sure your gas supply is right for
your heater. Otherwise, call dealer
where you bought the heater for proper
type heater.
Figure 4 -Minimum Clearance to Wall and Ceiling
CLEARANCES TO COMBUSTIBLES
Carefully follow the instructions below.
This stove is a freestanding unit
designed to set directly on the floor.
IMPORTANT: You must maintain mini-
mum wall and ceiling clearances dur-
ing installation. The minimum clear-
ances are shown in Figure 4. Measure
from outermost point of stove top.
If heater is installed directly on
carpeting, tile or other combustible
material, other than wood flooring, the
heater shall be installed on a metal or
wood panel extending the full width and
depth of the heater.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a
three-prong (grounding) plug for your
protection against shock hazard and
should be plugged directly into a
properly grounded three-prong
receptacle.
IMPORTANT: Installing heater in
rooms without enough ventilation air
may cause mildew to form from too
much moisture. See Air for Combus-
tion and Ventilation, pages 5 and 6.
NOTICE: This heater is intended
for use as supplemental heat. Use this
heater along with your primary heat-
ing system. Do not install this heater
as your primary heat source. If you
have a central heating system, you
may run systems circulating blower
while using heater. This will help cir-
culate the heat throughout the house.
In the event of a power outage, you
can use this heater as your primary
heat source.
WARNING: A qualified service
person must install heater. Follow all
local codes.
WARNING: Never install the
heater
l in a bedroom or bathroom
l in a recreational vehicle
l where curtains, furniture, clothing,
or other flammable objects are less
than 42 inches from the front, top, or
sides of the heater
l in high traffic areas
l in windy or drafty areas
CAUTION: This heater creates
warm air currents. These currents
move heat to wall surfaces next to
heater. Installing heater next to vinyl
or cloth wall coverings or operating
heater where impurities (such as
tobacco smoke, aromatic candles,
cleaning fluids, oil or kerosene
lamps, etc.) in the air exist, may dis-
color walls.
WARNING: Maintain the mini-
mum clearances. If you can, provide
greater clearances from floor,
ceiling, and adjoining side and back
walls.