Procom SN250TYLA-D Stove User Manual


 
3
SAFETY
INFORMATION
Continued
15. Turn off and unplug heater and
let cool before servicing. Only a
qualified service person should
service and repair heater.
16. Operating heater above eleva-
tions of 4,500 feet could cause pilot
outage.
17. Do not operate heater if any log
is broken. Do not operate heater
if a log is chipped (dime-sized or
larger).
18. To prevent performance
problems, do not use fuel tank of less
than 100 lbs. capacity.
LOCAL CODES
lnstall and use heater with care.
Follow all local codes. In the
absence of local codes, use the
latest edition of The National Fuel
Gas Code. ANSZ223.1, also known
as NFPA54*.
*Available from:
American National Standards
lnstitute, lnc.
1430 Broadway
New York. NY10018
National Fire Protection
Association, lnc.
Batterymarch Park
Quincy. MA 02269
This heater is designed for vent-
free operation. State and local
codes in some areas prohibit the
use of vent-free heaters.
UNPACKING
1. Remove top inner pack.
2. Tilt carton so that fireplace is
upright.
3. Remove protective side packaging.
4. Slide fireplace out of carton.
5. Remove protective plastic wrap.
6. Remove screen by lifting and then
pulling forward.
7. Remove log set by cutting plastic
ties.
8. Carefully unwrap logs.
9. Check for any shipping damage. If
fireplace or logs are damaged,
promptly inform dealer where you
bought the fireplace from.
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an
Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/
pilot is a required feature for vent-
free room heaters. The ODS/pilot
shuts off the heater if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor.
This system requires no matches,
batteries, or other sources to light
heater.
PRODUCT IDENTIFICATION
Figure1-Compact Vent-Free Fireplace
Decorative Frame
Heater Cabinet
Grill
Logs
Heater Controls
(Inside Door)