Procom SFE33RE-DO Indoor Fireplace User Manual


 
6
Operating Instructions
Before programming your transmitter you must
first insert three triple AAA batteries.
Make sure the main power on/off swith is in ON
position.
1.The Mode setting:
Press the SET button, then the AUTO light
will flash. Press the SET button again, and
then the MANUAL light will also flash. The
AUTO light and the MANUAL light will flash
alternately and continuously. Next press EN-
TER button to select the auto mode or manual
mode.
a.When selecting AUTO mode:
Select AUTO and press the ENTER button
to activate , then press the SET button, next
the Temperature, Flame, Light, lamp sym-
bols will flash alternately. Next press the
button or the button to select the desired
temperature setting. When the temperature
setting has been selected, press the SET
button to lock in the temperature setting, next
set the following functions that appear on the
transmitter. When the last function setting has
been completed, press the ENTER button,
and the symbols will stop flashing.
b.When selecting MANUAL mode:
Select MANUAL and press the ENTER but-
ton to confirm, then press the SET button,
the Flame, Light, lamp, Heating level sym-
bols will flash alternately. The next symbol will
flash automatically set the functions as they
appear. When the last function setting has
been completed, press the ENTER button,
and the symbols will stop flashing.
5
Heater Front View
Remote Control Front
Remote Control Back