Filter
Top Products
6
MAINTENANCE OF MOTORS
The motors used on the fan and flame genera-
tor assembly are prelubricated for extended
bearing life and require no further lubrication.
However, periodic cleaning/vacuuming of the
fan/heater unit is recommended.
WARNING: Make sure that the
power is turned off before
proceeding.
GLASS INFORMATION
1.Under no circumstances should this product be
operated with missing or broken glass.
2.Do not strike or slam the glass.
3.Do not use abrasive cleaners to clean the glass.
4. Replacement glass is available from the manu-
facturer and replacement should be carried out
by a qualified service person.
5
SERVICE INSTRUCTIONS
WARNING: Disconnect power before
attempting any maintenance or
cleaning to reduce the risk of fire,
electrical shock or personal injury.
REPLACING LIGHT BULBS
This fireplace uses clear 220 Volt, 60 Watt, E-14
socket base light bulbs (small base, chandelier
candle type). The 60 Watt bulbs are located under
the log set/ember bed. For convenience, if one of
the bulbs burns out, it may be a good idea to re-
place all of the light bulbs.
1. Turn off power to the unit by unplugging the power cord.
2. Let fireplace cool if it has been operating.
3. Remove the two screws on the top corner of screen. Pull
the screen upward slightly, and then pull out.
4.Remove the four screws that secure the log set/em-
ber bed in position.
5. Remove log set / ember bed and grate assembly.
6.Examine the bulb(s) to determine which bulbs need
to be replaced.
7. While holding the socket, unscrew defective bulb(s)
counterclockwise.
8.Install the new light bulb(s) by holding the socket and
screwing clockwise.
9. Reinstall the log set/ember bed, grate assembly and
screen. Follow the above procedure in reverse order.
WARNING: Do not exceed 60 Watts
per bulb. The use of higher rated
bulbs may result in a fire causing
property damage and personal
injury.
Note: SFE23RE uses three lights bulbs.
SFE33RE uses four lights bulbs.