Procom SSU320RHN-GB, SSU320RHN-B, SSU320RHN-G, SSU320RHN-S, SSU320RHN-GB, SSU320RHN-B, SSU320RHN-G, SSU320RHN-S Stove User Manual


 
12
Fig 15 - Control board
SETTING TIMER
1. AUTO ON:
With burner off, press TIMER button.
Then press or to change to the
scheduled time, then press the TIMER
button again, the TIMER starts timing
and the TIMER will flash and the green
operation light flashes. Burner will au-
tomatically come on at set time.
2. AUTO OFF:
With burner operating, press TIMER
button. Then press or to change
to the scheduled time, then press the
TIMER button again, the TIMER starts
timing and the TIMER will flash and the
green operation flashes. Burner will au-
tomatically shut off at set time.
TO TURN OFF GAS
TO APPLIANCE
Shut off heater
1. Press the IGN/OFF button.
2. Set Switch on OFF position or un-
plug the electric power to the heater.
(See Figure 12)
8. Press BURNER button for desired
burner operation.
AUTO: Burner will automatically turn
on and off.
MAN: Burner operates continuously.
9. If the appliance will not operate, fol-
low the instructions To Turn Off Gas
To Appliance and call your service
technician or gas supplier.
Fig 13 - Front of Remote Control
SETTING CLOCK
Press CLOCK button for hours or
minutes. Press or for correct time.
Press CLOCK button again to set time.
LOCKING REMOTE CONTROL
(child proof)
1.Key press locking:
Press LOCK button, a symbol will
appear on the LCD.
2.Key-press unlocking:
Press , then press LOCK button to
unlock.
OPERATING FAN
Press FAN button for desired fan
operation.
AUTO: Blower will come on several
minutes after burner comes on and will
go off several minutes after burner goes
off.
MAN: Blower operates continuously.
OFF: Blower is off.
MANUAL OPERATING
INSTRUCTIONS
We provide the manual control sys-
tem just in case of power shortage.
Install battery for Manual Ignitor:
1. Unscrew the ignitor cap.
2. Insert a AAA type battery with its an-
ode (+) pointing out.
3.Screw the ignitor cap back.
Note: We recommend that the battery
be taken out of the ignitor when the
power supply gets right.
LIGHTING INSTRUCTIONS
If power is off, you can operate the
fireplace manually.
1. STOP! Read the safety information
on page 11.
2. Check that gas supply to heater is
on.
3. Open bottom front access panel.
4. Push in gas Control Knob slightly
and turn clockwise to the OFF
position. If Control Knob is on ELEC-
TRIC position, press in the Control
Knob and turn counterclockwise
to OFF position.
NOTE: Knob cannot be turned from
PILOT/IGN to OFF unless knob is
pushed in slightly. Do not force.
Fig 14 - Back of Remote Control
(cover removed)
OPERATING HEATER
Continued
SETTING TEMPERATURE
With burner is on Auto position, press
or to change to the desired
temperature.