Filter
Top Products
Premier Heat Pumps – Water Heater and Chiller Manual
Page 14
4 - Use in Standard Mode
Starting operation
Press the power button when the unit has received the signal it gives out
two 'beep' tones. The operation light switches on and the heat pump water
heater starts operation. The compressor will restart after 3 minutes to protect
the system if the interval is shorter than 3 minutes from the last shut down to the
present switch on.
Mode Selection
Press the 'M' button to chose the mode of heating and cooling (this key is
invalid for the single water chiller or single water heater)
Temperature Setting Selection
1) Press "Temperature Adjustment Button to set the temperature 1
degree higher
2) Press "Temperature Adjustment Button to set the temperature 1
degree higher
3) Temperature range is set in heating mode: 45°C to + 55°C (Single water
chiller is without this function)
4) Temperature range is set in cooling mode: 10°C to + 35°C (Single water
heater is without this function)
Timer Switch On
1) When the heater is off press the
timer-on button to set time for the
timer-on switch. Press the button once to change the time interval of 1
hour in a cyclic manner of 1,2,...24,1,2 (The display shows the previous
time as the starting time of the present setting)
2) When it reaches the switch-on time, the heat pump water heater will
operate in the preset time mode.
3) Press the timer-on
button again, and the set up is cancelled.
4) If the on/off button is pressed while the unit is under the timer on
setting, the unit will start immediately. The timer setting is at that point
cancelled.
Timer-Off Switch
1) When the heater is on, press the timer-on button to set time for the
timer-on switch. Press the button once to change the time interval of 1
hour in a cyclic manner of 1,2,...24,1,2 (The display shows the previous
time as the starting time of the present setting)