The DigiPro comes with a Crevice Tool, Dusting Brush, and
Upholstery Tool. Tools are stored inside the canister unit. To reach
them, simply lift up the Tool Storage Cover Release. Tools may be
attached on the Handle or, where longer reach is needed, to the
Extension Wand.
To attach a Tool to the Handle, press the Handle Release
button and pull up until the Handle disconnects from the
Extension Wand. Slide the Handle over the Tool. Make
sure it is secure before using.
To attach a Tool to the Extension Wand, press the
Powerfoot Release button near the base of the Powerfoot
and pull up until the Extension Wand is released from the
Powerfoot. Slide the Extension Wand over the Tool. Make
sure it is secure before using.
The DigiPro handles all types of basic household cleaning needs. It
can be used on all types of carpeting, wood floors, linoleum,
upholstery, and curtains. It can be adjusted manually for any
operation or set to respond automatically to each surface. Its wide
coverage area makes it ideal for cleaning in corners and along
baseboards. Its easily maneuverable canister fits on stairways and
can be used with the Extension Wand and Tools to clean curtains
and hard-to-reach spaces.
The Power Cord is located in the rear of the unit. Pull out the
Power Cord gently. It will extend up to 22 feet. When removing
the Power Cord from the electrical outlet, switch off the power and
grasp the plug. Your vacuum is equipped with an automatic
rewind button. When cleaning is finished, switch off the power
and disconnect the plug from the electrical outlet. Press the Cord
Rewind Button ( ) and the cord will rewind automatically.
With the Power Cord plugged into an electrical outlet, turn the
power on and off by pushing or stepping lightly downward on the
Power Switch (. ).
Located on the Handle, this activates the Brush Roll for carpet and
most floor cleaning operations.
6
Special Tools
Operation / Maintenance
Power Cord
Power Switch
DirtLifter
®
PowerBrush Switch
1.
2.