![](http://pdfasset.owneriq.net/1/ba/1ba20926-4ee6-3094-096a-b6f4fbbad5ef/1ba20926-4ee6-3094-096a-b6f4fbbad5ef-bg7.png)
◗ If the adapter or charging base is damaged, always have it replaced
by one of the original type to avoid a hazard.
◗ FC6092 only: if the car cord or car plug is damaged, stop using
the car cord and have it replaced by one of the original type.
◗ Never suck up water or any other liquid. Never suck up ashes
until they are cold.
◗ Never immerse the vacuum cleaner, the adapter or the charging
base in water.
◗ Remove the adapter from the wall socket before cleaning the
charging base.
◗ Only charge the vacuum cleaner with the adapter and charging
base supplied. During charging, the adapter will feel warm to the
touch.This is normal.
◗ Always switch the vacuum cleaner off after use.
◗ Keep the appliance out of the reach of children.
◗ The voltage on the contact points in the charging base is low
(max. 30 volts) and therefore not dangerous.
◗ Never block the exhaust air openings during vacuuming.
◗ Switch the appliance off when recharging it.
◗ To avoid the risk of electric shock, be careful when drilling holes
in the wall to attach the wall mounting bracket, especially close to
a wall socket.
◗ Always use the appliance with the filter unit.
◗ Always use the appliance with the nozzle insert in place.
Preparing for use
Attaching the charging base to the wall
1 Screw the wall mounting bracket to the wall with the screws
supplied with the appliance (fig. 2).
2 Attach the charging base to the wall mounting bracket (fig. 3).
3 Attach the nozzle & stick holder to the wall mounting bracket
(FC6094 only).
4 Screw the nozzle & stick holder to the wall with the screws
supplied with the appliance.
ENGLISH 7