Filter
Top Products
◗ Keep the appliance out of the reach of children.
◗ The voltage on the contact strips in the charging unit is low (max.
12 volts) and therefore not dangerous.
◗ Never block the exhaust air openings during vacuuming.
◗ Switch the appliance off when recharging it.
◗ Always use the vacuum cleaner with filter unit.
Preparing for use
Installing the charging unit
1 Attach the charging unit to the wall as indicated in the figure
(fig. 2).
If you attach the charging unit to the wall, the space between the screw
holes should be 70 mm.
2 You can also place the charging unit on a horizontal surface
(e.g. a table or desk) (fig. 3).
3 Excess mains cord can be wound round the charging unit (fig. 4).
Charging the appliance
Charge the appliance for at least 16 hours before you use it for the first
time.
1 Insert the adapter into the wall socket.
2 Place the vacuum cleaner on the charging unit (fig. 5).
◗ The charging light will go on to indicate that the appliance is
charging (fig. 6).
B
The charging light will stay on as long as the appliance is connected to
the charging unit and the adapter is in the wall socket.
B
The charging light does not give any information about the charge level
of the built-in batteries.
B
To optimise the lifetime of the rechargeable batteries, periodically
discharge them completely by letting the appliance run until it stops
and then recharge them fully again.
ENGLISH 7
4222 003 30584 19-12-2006 07:24 Pagina 7