Philips AMC 45 Air Conditioner User Manual


 
OPERATING INSTRUCTIONS
Before operating the unit for the first time, it is necessary to install the batteries in the
remote controller.
! Batteries are located at the back of the
remote controller (Model AMW25, 30) and
at the front of the remote controller (Model
AMW45, 60).
! Open the battery holder by simultaneously
pushing downwards and inwards at the
area marked "OPEN"
! Use only "AAA" alkaline batteries
! Dispose of used batteries correctly, in a
manner not causing pollution or harm to the
environment.
OPERATING GUIDE MODEL: AMW 25, 30
! Start air conditioner. Point the remote controller at the fan coil and press ON/OFF button.
! Select the operational mode. Press either "Cool", "Dry" or "Vent" button to select the desired
mode.
! Set temperature. Press "+" or "-" button to set desired temperature.
! Select fan speed. Press "Fan" button to select desired fan speed.
! Set airflow position. Press "Vane" button to adjust airflow direction or to set vane to auto
swing.
! Set Timer. If required, press "Time" button to set timer On or Off. After pressing "Time"
button, the Time display on the LCD will start to flash. Press "+" or "-" to set the time before
flashing stops.
! Sleep mode. Select sleep mode by pressing "Time:" button until "Sleep" appears on the LCD
display. Sleep mode allows the air conditioner to raise the room temperature by up to 2°F from
set temperature while you sleep to save power.