Petsafe PPA11-13141 Door User Manual


 
www.petsafe.net 9
NOTE:
Inspect location of screw marks to make sure they will not be in contact
with glass on either the sliding glass door or the Patio Panel when drilling. If
needed, move the template over slightly and remark the screw holes.
Patio
Panel
4B
4B
Drill four
7
/
64
” (2.5 mm) holes. DO NOT
drill completely through the other side of the
sliding glass door or Patio Panel.
Patio
Panel
4C
4C
Secure the latch and keeper with four
3
/
4
” fl at head sheet metal screws. DO NOT
OVERTIGHTEN.
Helpful Tip: If overtightening results and you
have stripped the connection, move the latch
slightly up or down and re-drill mounting
holes. Another option is to drill existing holes
to a larger size and install plastic anchors.
Plastic anchors can be purchased at any local
hardware or home improvement store.
Step
5
Install Glass Sweep and Weather Stripping
5A
Patio door shown here slightly open
Freedom
Patio Panel Pet Door
Install glass sweep here
Install weather stripping here
5A
The glass sweep should be
installed on the back edge of the
sliding glass door to form a seal
between the sliding glass door
and the stationary glass door. The
weather stripping should be
installed on the front edge of the sliding glass door to form a seal between the
Freedom
Patio Panel and the sliding glass door.