Filter
Top Products
www.petsafe.net 7
Step
3
Attach the Patio Panel
Pre-drilled
Holes
Height
Adjuster
3A
3A
Slide the Patio Panel out slightly from
door jamb to show pre-drilled holes in height
adjuster. Drill
7
/
64
” (2.5 mm) holes through the
two pre-drilled holes on interior side of height
adjuster. Secure height adjuster to Patio Panel
using two
5
/
8
” sheet metal screws. Slide Patio
Panel back against door jamb. Make sure it is
fl ush without any gaps.
12"
30.48 cm
1"
2.54 cm
3B
NOTE: If installing the Patio Panel into
a recessed sliding glass door frame,
contact our Customer Care Center or visit
www.petsafe.net for a Metal Bracket Kit,
MPA00-12891 and installation instructions.
NOTICE
Prior to installation and drilling, consult your
sliding glass door manufacturer’s warranty.
Unauthorized changes or modifi cations may
void the warranty. Installing screws into vinyl
door frames or door jambs may crack the vinyl.
3B
To install the Patio Panel into an exposed
sliding glass door frame, fi nd the Patio Panel
center at top and mark on the sliding glass
door frame. Measure 12” from the top down the side of sliding glass door frame
and mark. Measure 1” above the pet door in the Patio Panel and mark on the
sliding glass door frame. Measure the center of the Patio Panel at the bottom and
mark on the sliding glass door frame.
3C
3C
Drill
9
/
64
” (3.5 mm) clearance
holes through your sliding glass
door frame ONLY at the locations
you just marked. DO NOT DRILL
INTO THE PATIO PANEL AT THIS
TIME.