Petsafe PPA11-13129 Door User Manual


 
8 1-800-732-2677
3D
3D
Before drilling into the Patio
Panel, it is important not to drill
inside the Patio Panel rib lines
where the glass is located. Only
drill into outer edge section. You
may need to slide Patio panel
over slightly to correct before
drilling.
3E
Drill
7
/
64
” (2.5 mm) holes through
the sliding glass door frame clearance
holes into the Patio Panel.
3E
3F
Fasten the Patio Panel to the
interior side of sliding glass door
frame using four
5
/
8
” sheet metal
screws. DO NOT OVERTIGHTEN.
Step
4
Install Lock
DOOR MATING LINE
KEEPE
RLATCH
Patio
Panel
Vertical
Center Line
4A
NOTICE
Prior to installation and drilling, consult your
sliding glass door manufacturer’s warranty.
Unauthorized changes or modifi cations may
void the warranty. Installing screws into vinyl
door frames or door jambs may crack the vinyl.
4A
Close the sliding glass door tightly against
the Patio Panel. Determine the location for the
Latch at a convenient height for you from the
fl oor. Using the template provided (located on
the last page of the Installation Guide) align
vertical center line on template with the door
line between the sliding glass door and the
Patio Panel. Keep the latch side of the template to the right. Tape template in
place and mark locations for the mounting screws. Remove template.
3F