Petsafe PPA11-13125 Door User Manual


 
www.petsafe.net 5
Bottom Door Section - Section of Patio Panel with the pet door
Height Adjuster - A metal panel with springs located above the top door section to
adjust Patio Panel height
Sliding Glass Door Frame Opening - Opening in sliding glass door between the
upper door track and the lower door track
Exposed Sliding Glass Frame - Sliding glass door frame that is visible and exposed
in interior and exterior wall
Recessed Sliding Glass Frame - Sliding glass door frame that is fl ush with or barely
visible in interior or exterior wall
Rise - The height from the fl oor to the bottom of the fl ap in the pet door. It is the
height the pet must step over to enter or exit the pet door.
Patio Panel Rib Line - Raised ribbed lines on left and right side of Patio Panel frame
to indicate drilling outside of rib line area. Do not drill inside of the rib line as glass is
present and will break if drilling occurs in this area.
Operating Temperature Range: 0º F to 100º F (-18º C to 38º C)
Installing Your Freedom
Patio Panel
THE STEPS BELOW ARE FOR AN EXPOSED SLIDING GLASS FRAME INSTALLATION. IF
INSTALLING THE PATIO PANEL INTO A RECESSED SLIDING GLASS DOOR FRAME, CONTACT OUR
CUSTOMER CARE CENTER OR VISIT WWW.PETSAFE.NET FOR A METAL BRACKET KIT,
MPA00-12891 AND INSTALLATION INSTRUCTIONS.
NOTICE
Prior to installation and drilling, consult your sliding glass door manufacturer’s warranty.
Unauthorized changes or modifi cations may void the warranty. Installing screws into vinyl door
frames or door jambs may crack the vinyl.
Step
1
Measure
1
1
Prior to any Freedom
Patio Panel Pet Door
purchase, you must determine the height of
your sliding glass door frame opening. Measure
from highest point in upper door track to lowest
point in lower door track.