Filter
Top Products
10 Customer Care Center 1-800-732-2677
Pairing the Receiver Collar for One
Dog Operation
To pair the Receiver Collar to work with a new Handheld Transmitter or to pair a new
Receiver Collar to work with your existing Handheld Transmitter:
1. Turn the Receiver Collar off.
2. Press and release the Transmitter’s Dog Select Button and ensure the Red LED
flashes one time to indicate Dog 1 is set.
3. Press and hold the On/Off Button on the Receiver Collar continuously for 5 seconds,
then release the button. The Green LED flashes once every second after the button is
released and waits to receive an ID for up to 10 seconds.
4. Press and release any blue correction button once during the 10 second
programming mode. (This sends the Transmitter’s unique ID to the Receiver.)
5. When the Green LED light on the Receiver flashes 5 times, the new ID has been
received. This can be verified by pressing any button on the Transmitter.
6. If the Receiver does not receive the new ID, it will automatically exit the pairing mode
and retain its previous ID.
Pairing the Receiver Collar for Two
Dog Operation
For a 2 Dog System, additional Receiver Collars are available at www.petsafe.net or
through our Customer Care Center.
Adding Dog 2
Remote Transmitter
1. Set the Level Select Switch to 2.
2. Press and hold the Transmitter’s Dog Select Button continuously for 5 seconds, then
release the button. (The Green LED will blink 3 times.)
3. Press and release the Transmitter’s Dog Select Button again and ensure the Green
LED flashes one time to indicate Dog 2 is set.
Receiver Collar
1. With the Receiver in the off position, press and hold the On/Off Button continuously
for 5 seconds, then release the button. The Green LED will flash once per second even
after the button is released for up to 10 seconds.
2. During this 10 second programming mode, press and release any blue correction
button on the Transmitter once. (This sends the Transmitter’s unique ID to the Receiver.)
3. The Green LED light on the Receiver Collar will flash 5 times. The new ID is now set.
To verify press any of the blue correction buttons.
Multi-Dog Functions
1. To select between Dog 1 and Dog 2, press and release the Dog Select Button to
toggle back and forth between Dog 1 (Red LED) and Dog 2 (Green LED).
2. The Transmitter will remember the last dog selected.
Step
4
Step
5