Filter
Top Products
2
Fig. 1 Side view of interface with dip switches in correct position
OFF
ON
5. Installation
1. When making electrical connections we always recommended discon-
necting the vehicle’s battery from the electrical system before performing
the installation.
2. Carefully remove the trim panels covering the 7mm bolts that secure
the radio into the dash cavity. Remove these bolts, and carefully pull the
radio from the dash of the vehicle. This will provide access to the factory
radio connectors where you will connect the Media Gateway harness.
3. Disconnect the factory 24-Pin harness and 12-Pin harness from the
back of the radio (if present). Disconnect the antenna from the radio.
4. Connect the 8-Pin iPod docking cable into the rst port on the Media
Gateway (farthest away from dipswitches). Carefully run the 11 foot iPod
cable behind the dash to the location where the iPod will be mounted or
stored (for example the glove box or center console). This location will
vary based on the vehicle, and the customer’s prefrence. When running
this cable through the dash be sure to secure it away from moving parts
or sharp metal edges that may damage the cable.
5. If connecting the HD Radio Tuner (HDRT sold separately), make the
following connections before connecting the PXAMG to the vehicle. Plug
the 3 foot HD Radio Cable (8-Pin mini-din to 8-Pin mini-din) into the
second port (closest to the dipswitches) on the Media Gateway. Connect
the other end of this cable into the HD Radio tuner. Connect the fac-
tory antenna cable into the antenna connection on the HD Radio tuner
(HDRT) Using a BestKits BAA5 antenna adaptor or eqivilalent if needed
to make this connection.
6. Locate the 24-pin and 12-pin male connectors on the PGHGM3 har-
ness, plug these connectors into the back of the radio. Plug the Black
micro-t 24-pin connector on the PGHGM3 harness into the PXAMG
Media Gateway box.