Filter
Top Products
7
Installation of indoor unit
In case of rear and right direction piping
(1) Pass the drain pipe through the wall hole, and hang the indoor unit
to the top end of the installation plate.
(2) Check that top end of the installation plate is inserted in by moving
the indoor unit to left and right sides.
(3) Fix bottom end of the installation plate and the lower cabinet with
screw so that the indoor unit does not move.
Removing of indoor unit right side plate
Remove the right side plate as the following procedure.
(1) Remove two side plate fixing screws.
(2) Remove the side plate by turning the gray colored part counter-
clockwise to remove hooks in the square hole of the suction grille.
(3) When piping is in direction from right side, cut off the knockout of
the side plate with knife, etc, and finish the end face.
Lower cabinet
Hang up
Installation
plate
Screwing
1
2
Side plate
fixing screws
Square hole
Screw cap
Hook
In case of rear direction piping
In case of right direction piping
• Insert the right side plate observing click of the side
plate. (Refer to right side plate installation drawing.)
• Fix the side plate, and cover the screw head with
attached cap.
In case of left direction piping
Work after removing the lower cabinet.
(1) Remove the left/right side plates.
(2) Remove two screws of the lower cabinet.
(3) Pull the lower cabinet toward you lowering a little.
A
Be sure to support A part with
hands while pipe is formed.
Knockout of right side plate
Be sure to support A part with
hands while pipe is formed.
Side face
Do not turn
horizontally.
Turn it upward/downward.
Knockout of
left side plate
Open
3
INSTALLATION OF INDOOR UNIT
2004/07/20, 14:48Page 7