Filter
Top Products
29
IntelliFlo VS-3050 Installation and User’s Guide
Warning and Alarm conditions
The IntelliFlo VS-3050 alarms and warnings are indicated by flashing LEDs on the control panel. For
example, if a “Drive Temperature” warning occurs, the LED will blink two times, then Off, then blink two
times. This sequence is repeated until the condition is cleared.
• Warning condition: If a warning condition occurs the pump will be continue to run but at a reduced
speed. The Green LED executes a sequence of blinks to indicate which alarm or warning has
occurred.
• Alarm condition: If an alarm condition occurs the pump will drive stop running. The red LED
flashes continuously to indicate the presence of an alarm. The alarm LEDs will reset when the
condition clears.
Alarm and warning LED sequence
Section 5
Troubleshooting
CAUTION: Before installing this product, read and follow all warning notices and
instructions on page ii.
ehtemitforebmuN
knilblliwDEL
mralAnoitpircseDnoitcA
2gninraWerutarepmeTevirDerutarepmetevirdevissecxEsahnafrotomehterusnE.1
.noitalitnevrofaeraetauqeda
.looco
twolladnarotompotS.2
otdeepsrehgihatarotomnuR.3
.wolfriagniloocevorpmi
5mralanwonknUeruliafcinortcelE.pmupt
eserotrewopelcyC.1
.evirdecalpeR.2
6mralAerutarepmeTevirDerutarepmetevirdevissecxEsahnafrotomehterusnE.1
.n
oitalitnevrofaeraetauqeda
otdeepsrehgihatarotomnuR.2
.wolfriagniloocevorpmi
7mralAtuOrewoPwolegatlovylppuS.
egatlovylppusreporperusnE
8mralAtnerrucrevOtnerrucevirdevissecxElacinahcem/diulfenimaxE.1
.daolrevofoecruo
srofmetsys
dnarotomezigrene-eD.2
.yleerfsnipsrotomfienimreted
.evirdecalpeR.3
9mralAegatlovrevO ssubevirdnoegatlovevissecxEsdeepsneewtebgnihctiwsdipaR.1
segatlovevissecxeesuacnac
.ssubCDs'evirdehtno
.egatlovylppu
sreporperusnE.2