Filter
Top Products
5
WARNING
The heater must be electrically grounded and bonded in accordance with local codes, or in
the absence of local codes, with the latest national electrical codes ANSI/NFPA No. 70. All
wiring must comply with all local codes, or in the absence of local codes, with the latest
national electrical codes ANSI/NFPA No. 70. For proper wire and/or breaker size, please
refer to specification sheet and your local licensed electrician. Always bond heat pump
cabinet to pool steel and ground to power supply.
The electrical panel has an isolated compartment, located within the mechanical
compartment to prevent corrosion. The heat from the compressor located just below
the electrical compartment helps eliminate moisture as well. This exclusive design
will substantially extend the life cycle of the heater. The fiberglass cabinets is
corrosion proof and is much stronger than plastic cabinets.
L.E.D. Diagnostic Lights
Heat Exchanger
Special Cupronickel Alloy
Encased In A Block of Foam
to Prevent Heat Loss & Corrosion
DESIGN ADVANTAGES
Internal Automatic Bypass
Free Flow 2" Plumbing
Automatically adjusts the water flow.
Lowest water flow restriction available.
2" PVC Water IN
15-90 GPM
2" PVC Water OUT with Elevated Fiberglass Bottom Pan for Proper Condensation Drainage.
Dual Thermostat
!