Filter
Top Products
3. The package includes two plastics feet,
which are needed when the fan is placed on
a surface rather than in a window.
ⅠUSED IN A WINDOW
1. Each side has two locks. Release the locks
at either one side or two sides to pull out the
extenders.
2. Put the locks back to fix the extender at desired length.
ⅡUSED AT SURFACE
The fan can be used at a surface besides a window. In this situation, just snap the two plastic feet
at the bottom of the fan body. No tools needed.
OPERATING INSTRUCTION
Plug it into an outlet. The red LED will display “ROOM”and two digits; this is the indoor
temperature.
ⅠPANEL OPERATION
The fan has two reversible motors. The rotation speed
and direction of each motor are controlled
independently using panel operation.
1. SPEED CONTROL
The three speeds— low (L), medium (M) and high (H)
are controlled by the left/right speed buttons and
showed by relevant left/right speed lights. For
example, when the light beside “L”is on, the speed is
low. When you press the “ON/SPEED1/OFF” /
“ON/SPEED2/OFF”button, the left/right motor starts
at low speed. Press the button repeatedly to select
the speed; the sequence of speed is low, medium,
high and off.
2. DIRECTION CONTROL
To exhaust, press the “DIRECTION1”/“DI-
RECTION2” button. Change the air direction by
pressing the button repeatedly.
To make the air exchange, set the two motors to
rotate in opposite direction.
3. TEMPERATURE SETTING
The fan can be set at any temperature from 65℉to 90℉. Press the “TEMP”button for several
seconds until the temperature LED starts blinking. Now the word “SET”shows while “ROOM”
disappears. Each time you press the “TEMP+” / “TEMP-” button, the temperature will
increase/decrease by 1℉. When it reaches a desired temperature, press “TEMP”button to stop
the blink and so the setting is confirmed. The two motors will be turned off automatically when the
Figure 1
Figure 2