Pella 802X0104 Window User Manual


  Open as PDF
of 8
 
E. Apply sill flashing tape #1.#UTAPIECEOFmASHINGTAPELONGER
than the opening width. Apply at the bottom of the opening as shown
%SOITOVERHANGSTOTHEEXTERIOR
Note: The tape is cut 12" longer than the width so that it will
extend 6" up each side of the opening.
2 WINDOW PREPARATION
A. Remove plastic wrap and cardboard packaging from window. DO NOT remove plastic
shipping spacers located between the window sash and frame. The shipping spacers will
help keep the window square during installation. DO NOT unlock or open the window
until it is fully fastened.
Note: If screens, grilles or hardware are removed from the window
at this time, label them and store them in a protected area.
2C
B. Designer units with half screen only:
1. Remove the screen from the window.&ROMTHEEXTERIOR
pull one side of the screen near the shipping clips until the
clips disengage from the window.
Rotate the screen shipping clipsTOWARDTHEEXTERIOROFTHE
screen (in the direction of the arrows) until they snap free
from the screen.
3. Set the screen aside in a safe location.
4. Discard the screen shipping clips.
F. Tab the sill flashing tape and fold. Cut 1" wide tabs at each corner
FROMEACHSIDEOFCORNER&&OLDTAPETOTHEEXTERIORAND
PRESSlRMLYTOADHEREITTOTHEWATERRESISTIVEBARRIER
C. Fold out installation fin to 90°. Be careful not to remove or
TEARTHElNCORNERS
Note: If the fin is not at 90
°, the window will not line up
correctly on the interior.
'Apply sill flashing tape #2.#UTAPIECEOFmASHINGTAPELONGER
than the opening width. Apply at the bottom, overlapping tape #1 by
ATLEAST$ONOTALLOWTHETAPETOEXTENDPASTTHEINTERIORFACEOF
THEFRAMING'
Note: The flashing tape may not fully cover the framing members.
(Install and level sill spacers. Place 1" wide by 3/8" thick spacers on
THEBOTTOMOFTHEWINDOWOPENINGFROMEACHSIDE3PACERSARE
also required at points where windows are joined in multiple window
applications. Add shims as necessary to ensure the spacers are level.
Once level, attach spacers and shims to prevent movement.
Note: Improper placement of shims or spacers may result in
bowing the bottom of the window.
£
TWO OR MORE PEOPLE WILL BE REQUIRED
FOR THE FOLLOWING STEPS.
%*4$"3%
164)
%*4$"3%
164)
4IJQQJOH
$MJQ
ÓÓ
Ó£
1VMMTDSFFOOFBS
TIJQQJOHDMJQ
£




£

£
1 ROUGH OPENING PREPARATION (continued)
 previous next