Filter
Top Products
Pelco Manual C379M-G (12/98) 9
3.3.1 Mating Connector Assembly
To assemble the mating connector, refer to Figure 2 and perform the following steps.
The instructions that follow apply to all AMP style connectors regardless of pin size
or pin number.
1. Slide the connector clamp assembly over the conductor cable. If the diameter
of the conductor cable is such that the rubber boot will slide over it easily, slide
the rubber boot onto the conductor cable at this time. If not, discard the rubber
boot.
2. Refer to Detail A in Figure 2. Prepare the wires from the conductor cable as
follows:
a. Strip at least 1-inch (2.54 cm) from the cable jacket to expose the wires.
You may need to strip more from the cable jacket if you have more wires.
b. Strip 1/8-inch (0.125 cm) from each wire.
c. Using an AMP style crimper, crimp the wires and their insulation to the
connector pins.
3. Slide the connector pins into the appropriate holes in the connector body until
they snap into place. Refer to detail B in Figure 2 and to Figures 3-6 for correct
pin arrangement, depending on model and options.
4. Push the connector clamp assembly (with boot, if used) toward the connector
body. Screw the clamp assembly onto the connector body, being careful not to
disturb the wires.
5. To complete the assembly, attach the appropriate clamp with the screws pro-
vided and tighten.
NOTE:
Contacts cannot be re-
moved from the connector without
the use of the appropriate AMP ex-
traction tool (ZT305183 for the 16-
pin connector or ZT91067-2 for the
28-pin connector), which is avail-
able from Pelco.
NOTE:
When a pan/tilt is mounted
in the inverted position, the LEFT/
RIGHT and UP/DOWN functions
are reversed during operation. To
correct this problem, reverse the
LEFT/RIGHT functions in the con-
trol cable (pins 3 and 7) at the pan/
tilt or control and the UP/DOWN
functions (pins 5 and 6) at the pan/
tilt or control.
Figure 2. Connector Assembly
OR
1"
1/8"
16-PIN
FRONT VIEW
12
36
710
1114
1516
00005
16-PIN
12
36
710
1114
1516
00005
13
48
914
15
20
2125
2628
28-PIN