Pelco HKHS3024 Electric Heater User Manual


 
4 C499M-A (11/05)
Installation
To install the HKHS3000 and HKHS3024, perform the following steps:
1. Remove the cover from the enclosure.
2. Attach the PC board/bracket assembly to the studs on the rear end plate (refer to Figure 1 and Figure 3) using the two 1/4-20 nuts supplied.
3. Install the heater pads onto the front of the body (end nearest window) by removing the backing and pressing in place onto the floor of
enclosure (refer to Figure 3).
4. Wire per wiring diagram in Figure 2.
Figure 1.
Heather Kit Installation
Figure 2.
HKHS3000 and HKHS3024 Wiring Diagram