Filter
Top Products
C1473M-C (4/05) 7
Installation
The following items are supplied:
Qty Description
1 EH2500 Series enclosure
1 Hex wrench, 3/32" (Pelco # ZT-ALLEN3/32)
1 Hex wrench, 5/64" (Pelco # ZT-ALLEN5/64)
1 1/4” x 1” O.D. fender washer
1 Desiccant bag
2 1/4-20 x .375-inch Phillips pan head screws and flat washers (for camera mounting; only one screw and washer required)
ENCLOSURE MOUNTING
The enclosure can be mounted to a wall/ceiling/pedestal mount, or pan and tilt. For proper installation, refer to the instructions supplied with the
mount or pan and tilt. The enclosure should be attached to the mount or pan/tilt by a minimum of two 1/4-20 fasteners (not supplied).
Always use a service loop, as shown in Figures 1, 2, 3, and 4 to prevent water from entering the enclosure.
Figure 1.
Typical Fixed Wall Mounting
Figure 2.
Typical Fixed Ceiling Mounting
Figure 3.
Typical Pan/Tilt Wall Mounting
Figure 4.
Typical Pan/Tilt Ceiling Mounting
ENCLOSURE
WALL MOUNT
WALL
CEILING
ENCLOSURE
CEILING MOUNT
ENCLOSURE
P/T
WALL MOUNT
WALL
CEILING
ENCLOSURE
P/T