Filter
Top Products
6 C2461M-A (7/03)
Attach to a 4S Deep Electrical Box
Refer to Figure 2 for the following steps. The installation instructions assume that the 4S box was
previously installed.
1. Attach adapter plate to the 4S box with the two 8-32 x .750-inch screws supplied.
2. Connect the video cable.
3. Connect the power wires.
Voltage Red Wire Black Wire
12 VDC + Ground
24 VAC ~ ~
AC Operation Only – If you are wiring more than one Camclosure system to the same
transformer, connect one side of the transformer to the red wire on all units, and connect the
other side of the transformer to the black wire on all units. Failure to connect all of the units
the same way will cause the cameras to be out of phase with each other and may produce a
vertical roll when switching between cameras.
4. Attach the back box to the adapter plate with the four 8-32 x .375-inch screws supplied.
Figure 2. Installation to 4S Deep Electrical Box
8.32 X .750 SCREW
(SUPPLIED)
8.32 X .375 SCREW
(SUPPLIED)
WALL OR
CEILING
ADAPTER PLATE
BACK BOX
4S DEEP
ELECTRICAL
BOX