Filter
Top Products
6 C2404M-A (4/05)
Installation
MOUNTING DIRECTLY TO SURFACE
WIRING THROUGH BASE
Follow the proceeding steps when feeding wire/cables through the base of the cover and back box:
1. Using the cover as a template, mark one
of the large hole positions onto the
mounting surface.
2. Cut out the hole in the mounting surface
for power and video wiring.
3. Pull video and power wires through the
hole in the cover.
4. Attach the cover to the mounting surface
(hardware not supplied). Use stainless
steel hardware when installing the
system outdoors.
5. Connect the video cable.
6. Connect the power wires.
•
Red wire - 24 VAC/12 VDC
•
Black wire - GND
7. Install the back box inside the cover. Rotate and position the back box so that the conduit plug
on the side of the box is located on the opposite side (180 degrees) from the notch on the side
of the cover. Use the supplied 8-32 x 0.375-inch screws and washers to secure the back box to
the cover
NOTE:
For vandal-resistant installations, the conduit plug located on the side of the back box
should be hidden if it is not used. To hide the conduit plug rotate the back box so that the plug
is located on the opposite side (180 degrees) from the notch on the side of cover.
COVER
BACK BOX
C2404M-A.book Page 6 Monday, April 18, 2005 9:11 AM