Filter
Top Products
6 C1303M-B (5/05)
3. Slide the camera module into the enclosure. Refer to Figure 3 to position the camera module properly in the enclosure. Carefully mate the
camera’s power connector to the mating connector located inside the enclosure.
Only models with wipers:
The tab located inside the enclosure must be pointing down before installing the camera module (refer to
Figure 3). To position the tab, place the wiper located at the front of the enclosure in the center of the viewing window (refer to Figure 4).
Figure 3.
Install Camera Module
Figure 4.
Center Wiper
WARNING:
Do not force the camera module into the enclosure.
CENTER
NOTCHES
TAB
CAMERA
MODULE
CAMERA
ENCLOSURE
CENTER WIPER