Filter
Top Products
10 User Guide
6.0 Disarming
When your system is disarmed, it deactivates any alarms in progress, and it deactivates the zones so the alarm will not be
triggered if zones are breached.
6.1 Entry Delay Timer
Your installer will program designated entry points (i.e. the front door) with an Entry Delay
Timer. This delay gives you time to enter the armed premises and enter your code to
disarm your system before the alarm is triggered.
6.2 Disarming an Armed System
You can only disarm an area to which your user access code is assigned. User access
codes with the “Arm Only” (section 7.6 on page 15) option enabled cannot disarm an
armed system.
How do I disarm the system?
1. Enter your [
ACCESS CODE].
2. Press the [
DISARM] button. If you have access to more than one area, select the
area(s) you wish to disarm (refer to section 6.2 on page 10).
To disarm a system in alarm:
1. Enter your [
ACCESS CODE].
2. In the case of a false alarm, call your monitoring station quickly to advise them of the
false alarm.
In the case of a burglar alarm, leave the premises and call the Police from a
safe location.
6.3 Alarm Memory Display
When an alarm occurs in a zone:
• The area and zone (i.e. Alarm Area 1 - Front Door) are displayed / zone’s LED
flashes even when the system is armed. The notification continues until disarming,
even if the zone is restored. (EVO641 / EVO641R only)
• The alarm memory will be erased after the next alarm occurs and a valid code has
been entered.
To view the alarms that occurred the last time the system was armed:
1. When the system is disarmed, the LCD keypad’s screen will display Alarm in Memory:
Press [mem]. The DGP2-648BL LED’s MEM action light will illuminate.
2. Press the [
MEM] button.
Each zone that was breached while armed will appear below Alarm in:.
The
MEM action light will flash and the numerical light(s) for each zone whose alarm
was triggered will illuminate.
3. Press the [
CLEAR] button to exit the Alarm Memory Display.
LCD LED
LCD LED
LCD
LED