Filter
Top Products
22 EVO96
Figure 8: Modifying illumination settings on the DGP2-648BL
9.3 Set Time & Date
To reset the time and date:
1. Enter your [
ACCESS CODE] and press the [TRBL] button or the [] key.
2. Press the [8] button.
3. To change the time, place the cursor under the number you want to change by using
the [S] button and enter the time according to a 24-hour clock (i.e. 9 a.m. is 09:00 and
9 p.m. is 21:00).
4. To change the date, place the cursor under the number you want to change and enter
the correct date according to year/month/day. On the DGP2-640 keypad, you will have
to press the [ ] key to not change an element of the date.
5. Press the [
ENTER] button to save and exit.
On the DGP2-648BL keypad, follow this procedure:
1. Enter your [
ACCESS CODE] and press the [TRBL] button or the [] key.
2. Press the [8] button.
3. Enter the hour and minutes according to the 24-hour clock (i.e. 9AM is 09:00 and 9PM
is 21:00).
4. Enter the correct date according to yyyy/mm/dd.
5. Press [
CLEAR].
9.4 Programming Chime Zones
You can program the keypad to emit a rapid, intermittent beep tone whenever designated
zones are opened or only when opened between certain hours. These zones are referred
to as Chime Zones. Your installer can also program your Chime zones to beep upon
closure.
How do I program chime zones?
1. Enter your [
ACCESS CODE].
2. Press the [9] key.
3. Press the [1] key to chime a zone. Enter the number corresponding to the zone to be
chimed, or use the
[
S
]
and
[
T
]
buttons to scroll the list of zones. Press the
[ACC]
button to chime or unchime the zone that appears on the screen. Press
[
ENTER
]
to
save.
OR
Press the [2] button to set the time period a chimed zone will beep. Enter the time that
the chimed zone(s) will start beeping when opened (HH:MM). Enter the time that the
chimed zone(s) will stop beeping when opened (HH:MM).
4. Press
[
CLEAR
]
to exit chime programming.
9.5 Panic Alarms
Your system can be programmed to send an alarm to your monitoring station to request
help from the police, a medical facility, the fire department, or anyone you wish when you
press a predetermined combination of buttons. To generate a panic alarm, simultaneously
LED
1. Enter your [ACCESS CODE]. Your keypad will emit
a Confirmation Beep. The
ACCESS action light will
flash.
2. Press the [6] key. Your keypad will emit a
Confirmation Beep, the Prg action light will
illuminate and the numerical light for the current
setting will illuminate.
3. Use the
[U] and [V] keys to increase or
decrease the illumination. The range is between
numerical light 1 to 8 (1 being the lowest and 8,
the brightest).
4. Press the [
ENTER] key to save and exit.
LCD ICON
LED
LCD ICON LED
LCD ICON LED