MA Motion Sensor (AMA1, AMB1, 2, 3)
2. External triggering type
HOW TO USE
• Wiring diagram of connector
Notes: 1. The output transistor has an open collector structure.
• Detection status: Output transistor ON (connected to GND)
• Non-detection status: Output transistor OFF (open state)
2. The status of the external trigger input is as follows:
• Open at the high level
• GND (less than 0.8V) at the low level
Under no circumstances must a high-level voltage be applied.
3. To maintain the power supply noise performance, be certain to connect a capacitor (33µF or more) to the sensor power supply input terminal in order to stabilize
the power supply voltage.
Built-in oscillation circuit type External triggering type
NPN output type
PNP output type
Notes: 1. Circuit stability time : Max. 12 ms
2. During the time taken for the circuit to stabilize after the power is turned
on, the ON/OFF status of the output transistor is not determined by
whether the sensor is in the detection status or non-detection status.
Note: The sensor recognizes at the V
TH → VTL edge of an external trigger that the
external trigger has been input.
VTH
VTL
OFF
OFF
ON
ON
•
•
ON
OFF
•
NPN output types
of the AMA series
AMB series
PNP output types
of the AMA series
Non-
detection
status
Detection
status
Non-
detection
status
Circuit
stability
time
Non-
detection
status
Detection
status
Non-
detection
status
Circuit
stability
time
Power supply
External trigger
Output transistor
(open collector)
Output transistor
VTH
VTL
Tt: Min. 5ms
Tr: Max. 5ms
Tw
Output
External trigger
Change
(ON to OFF or
OFF to ON)
Power supply
Output
+
+
3
1
Tr
4
2
GND
Min.
33 µF
Note 3.
Note 1.
N.C.
(No connection)
3
1
4
2
GND
Power supply
Output
+
+
Min.
33 µF
Note 3.
Note 1.
External trigger input
Note 2.
3
1
Tr
4
2
GND
Power supply
Output
+
+
Note 1.
N.C.
(No connection)
Min.
33 µF
Note 3.
3
4
2
GND
1
Power supply
Output
+
+
Min.
33 µF
Note 3.
Note 1.
External trigger input
Note 2.
All Rights Reserved © C
OPYRIGHT Panasonic Electric Works Co., Ltd.
