Filter
Top Products
12
3.7. Motor Protector Replacement
3.7.1. Removal
1. Remove the seven (7) screws that secure the dust cover
and remove the dust cover.
2. Remove the motor protector located inside the dust com-
partment by pushing in on the two retaining tabs. Do one
side at a time while pushing out on the motor protector
from inside the dust compartment.
3. Once the motor protector has been removed it can be dis-
assembled for replacement of parts.
3.7.2. Installation
1. Reinstall the motor protector into the dust compartment
by aligning the two tabs under the top flange with the slots
in the dust compartment by applying pressure from the
back of the vacuum until it snaps into place.
2. Install the dust cover by first ensuring all wiring is routed
correctly so that no wires may be pinched during assem-
bly.
NOTE: For general servicing, it is necessary to eliminate pinch-
ing of any wire during reassembly. After servicing any electrical
component or electrical enclosure, the unit should be reassem-
bled and checked for dielectric breakdown or current leakage.