Filter
Top Products
9. Press the mounting plate tightly against the wall and se-
cure to the outside of the wall sleeve with the supplied
screws(screw II). (Fig. 7)
8. Using enclosed template (pattern paper), mark and cut
the opening in the interior wall cover. (Fig. 6)
10. Remove the grille from the fan unit.
Press the spring locks on the sides and pull the grille
back. (Fig. 8)
11. Attach the electrical connectors to each other, hook the
frame latches onto the mounting plate latch, and secure
the fan unit to the mounting plate with the supplied screw
(screw III). (Fig 9)
12. Reattach the grille to the frame.
6
Installation I (In new construction) - continue
Fig. 7
Fig. 8
Grille
Fan unit
(Frame)
7. Insert the attached exterior hood from the outside to cover
the wall sleeve, and secure it with four screws or nails.
Cover the seam between the wall sleeve and exterior
hood with aluminum tape, and apply mortar or caulking
around the exterior hood flange to prevent rainwater from
coming in. (Fig. 5)
Fig. 6
Interior wall
material
Fig. 5
Exterior hood
Finish with mortar
or caulk.
Aluminum
tape
Seam
Mounting plate
Latch
Latch
Fig. 9
Frame
Grille
CAUTION:
Do not pinch the power cord with the frame.
CAUTION:
Press on the grille until it clicks.
NOTE:
Be sure to paint the exterior hood. Before painting, thor-
oughly wipe off any oil on the surface. Also make sure that
the paint does not enter inside of the hood.