EN-1
EN
1. Important Safety Instructions
Before using the system, be sure to read these “Important Safety Instructions”.
After reading this manual, save it in a convenient place.
Warning
Installation Precautions
• Do not install by yourself.
Installation should always be performed by your
dealer or a professional service provider.
Electric shock or fi re may result if an
inexperienced person performs any installation
or wiring procedures incorrectly.
• Use only specifi ed air conditioners.
Always use only air conditions specifi ed by the
dealer.
Precautions for Use
• Do not touch switches with wet hands.
Electric shock and damage to the system can
result.
• Protect the remote controller from water.
Damage to the system can result.
• Stop the system and turn the power off if you
sense unusual smells or other irregularities.
Continuing operation when the system is out
of order can result in electric shock, fi re, and
damage to the system. Contact your dealer.
Moving and Repair Precautions
• Do not repair.
Never repair the system by yourself.
• Contact your dealer before moving the system.
Contact your dealer or a professional service
provider about moving and reinstalling the
system.
Electric shock or fi re may result if an
inexperienced person performs any installation
procedures incorrectly.
Note:
• This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
• This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
• FCC Caution: To assure continued compliance,
follow the attached installation instructions.
Any changes or modifi cations not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate this equipment.