5
About the Controls on the Air Conditioner
2
1
7
4 6
3
5
About the Controls on the Air Conditioner
Controls
OPERATION
• To turn the air conditioner ON, push the button. To turn
the air conditioner OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the air conditioner is on the
High cool mode and the temperature is set at
72°F (22°C)
MODE
Every time you push this button, it will toggle between
COOL, ECONOMY, FAN, DRY.
TEMPERATURE SETTING
This button can automatically control the temperature of
the room. The temperature can be set within a range of
60°F to 86°F by 2°F. (16°C to 30°C by 1°C)
Select a lower number for a lower temperature in the
room.
FAN SPEED
Every time you push this button, it is set as follows.
{High(F3) → Low(F1) → Med(F2) → High(F3)...}.
ON/OFF TIMER
You can set the time when the unit will turn on or turn off
automatically by pressing the timer button. If the unit is
operating, this button controls the time it will be turned off.
If the unit is in off state, this button controls the time it will
start. Every time you push this button, the remaining time
will be set as follows.
- STOPPING OPERATION
• Every time you push this button, when the air
conditioner is operating, timer is set as follows.
(1Hour → 2Hours → 3Hours → 4Hours → 5Hours →
6Hours → 7Hours → 8Hours → 9Hours → 10Hours →
11Hours → 12Hours → 0Hour → 1Hour → 2Hours → ...)
• The Setting Temperature will be raised by 2°F(1°C)
30min. later and by 2°F(1°C) after another 30 min.
- STARTING OPERATION
• Every time you push this button, when the air
conditioner is not operating, timer is set as follows.
(1Hour → 2Hours → 3Hours → 4Hours → 5Hours →
6Hours → 7Hours → 8Hours → 9Hours → 10Hours →
11Hours → 12Hours → 0Hour → 1Hour → 2Hours → ...)
AIR SWING
This button can automatically control the air flow direction.
REMOTE CONTROL SIGNAL RECEIVER
DRY
When this unit is in dry mode, the fan rotates in low
speed. The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the
unit checks the room air temperature to set itself.