Panasonic CU-E24HKR Air Conditioner User Manual


 
5
TO SET THE TIMER
TO SET THE TIMER
, , and can be activated
in all modes and can be cancelled by pressing the
respective button again.
and or and can not
be activated at the same time.
and can be activated even when the
unit is turned off. In this condition, once e-ion indicator
is ON, the unit will operate with AUTO fan speed and
air swing.
TO SELECT FAN SPEED
(5 OPTIONS)
For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
AIR SWING
TO ADJUST AIRFLOW DIRECTION
(5 OPTIONS)
Keeps the room ventilated.
If AUTO is set, the louvers swing left/right and
up/down automatically.
In heat mode, the air blows horizontally for a while,
then starts to blow downwards and the air ow louvers
start to swing left/right after the temperature rises.
TO MONITOR AIR QUALITY
Patrol sensor detects air quality.
When air quality is unsatisfactory, e-ion operation will
start automatically.
TO ENJOY CLEAN & FRESH AIR
Generates negative ions to produce fresh air effect
and attract dust which will then be captured at the
positively charged e-ion lters.
TO ENJOY QUIET ENVIRONMENT
This operation reduces air ow noise.
TO ACHIEVE TEMPERATURE
QUICKLY
To turn ON or OFF the unit at a preset time.
Select ON or
OFF timer.
Set the time. Con rm.
• To cancel ON or OFF timer, press
or then
press .
When ON Timer is set, the unit may start earlier (up
to 30 minutes) before the actual set time in order to
achieve the desired temperature on time.
Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
.
OPTIONAL SETTINGS
OPTIONAL SETTINGS
Patrol starts automatically with the unit
switched on with .
Press and hold for 5 seconds, then release
to disable or restore this setting.
Press and hold for 5 seconds to dim or
restore the unit’s indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in
°C or °F.
Press and hold for approximately 5 seconds
to show 12-hour (am/pm) or 24-hour time
indication.
Press to restore the remote control’s default
setting.
,
Not used in normal operations.
Set the temperature 1°C higher in cool mode or 2°C
lower in heat mode than the desired temperature to
achieve a 10% power saving.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.