Filter
Top Products
QUIET
POW
E
RFUL
I
O
N
TIM
ERPO
W
E
R
CANCEL
O
FF
TIMER
ON
TIMER
FAN
S
PEED
AIR
S
W
ING
A
UTO
DRY
COOL
MODE
TIM
ER
ON
1 2 3
OF
F
CL
O
CK RE
S
ET
SET
CANCEL
TEMP
POW
ERFUL
FA
NSPEED
AIRSWING
OFF/ON
Q UIET
QUIET
POWERFUL
ION
SUPER
A LLERU-B USTER
TIMERPOWER
Air intake
Airflow direction louver
Ionizer
Air filter
Front panel
Indoor Unit
Outdoor Unit
Air inlet
(rear)
Air outlet
LCD display
Off/On
Fan speed selection
Clock setting
Memory reset
Temperature setting
Powerful operation
Operation mode
Quiet operation
Timer setting
Ion operation
Airflow direction
adjustment
Remote Control
Indicator
Supersonic air
purifying device
Auto OFF/ON
button
Receiver
Transmitter
Air inlet
(side)
Discharged air
Do not touch
during operation
Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
Troubleshooting
● Operation delayed for few minutes after restart.
➤ This is a normal self protection control.
● Sound like water fl owing during operation.
➤ Caused by refrigerant fl ow inside.
● Mist emerges from indoor unit.
➤ Condensation effect due to cooling process.
● Noisy during operations.
➤ Installation work could be slanted or front panel didn’t close properly.
● Remote control/display does not work.
➤ Check whether batteries are correctly inserted or need replacement.
● The unit cannot operate.
➤ Check either circuit breaker is tripped, power plug is inserted correctly or
timer is used correctly.
● Outdoor unit emits water/steam.
➤ Condensation or evaporation happens at piping surface.
OPEN
• Make sure it is not obstructed.
• Maximum distances: 10m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Remote Control Preparation
■ About
Remote Control Signal
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be
recycled or disposed of
properly.
1. Pull out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
5. Press again to confi rm
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Action
Operation
mode
Press once
Automatic
Operation
Press until “beep”
sound
Cooling
Operation
• To OFF, press again the Auto OFF/
ON button.
• To switch the remote control signal
receiving sound off or on.
1. Press until “beep” sound and
release.
2. Press again until “beep-beep”
sound and release.
3. Press to switch the sound off or
on.
(Long “beep” - OFF; short “beep”
- ON)
Auto OFF/ON Button
40
CS-W7DKR CU-W7DKR / CS-W9DKR CU-W9DKR / CS-W12DKR CU-W12DKR