Panasonic CS-MKE18NKU Air Conditioner User Manual


  Open as PDF
of 122
 
17
4. How to Test Run the Air Conditioner
After turning on the power of the air conditioner, use the
remote controller and follow the steps below to conduct the
test run.
(1) Set the remote controller in Test Run mode.
(Fig. 59a)
a)Press and hold the QUIET button and the 1HR.
TIMER button.
E7KHQSUHVVDQGKROGWKH$&/ 5HVHWEXWWRQZLWKD
pointed object such as the tip of a pen. After 5 sec-
RQGVUHOHDVHWKH$&/ EXWWRQILUVW
c)Then release the QUIET and 1HR. TIMER buttons.
d) appears and “oP-1” blinking in the remote con-
troller clock display area. (Fig. 59b)
(2) Start Cooling mode test run by pressing the ON/OFF
operation button of the remote controller. (Fig. 59a)
7KLVVWDUWVWKHIDQSURGXFLQJXQFRROHGIRUFHGDLUZLWK
the 3 indicator lamps (OPERATION lamp, TIMER
lamp and QUIET lamp) on the main unit blinking.
(Fig. 59c)
$IWHUPLQXWHVWKHV\VWHPVKLIWVLQWRFRROLQJRSHUD
tion, and cool air will start to be felt. Cooling mode test
run is unaffected by the room temperature.
(3) Press the ON/OFF operation button of the remote con-
troller again to stop the test run. (Fig. 59a)
 )LQDOO\SUHVVWKH$&/ 5HVHWEXWWRQRIWKHUHPRWHFRQ
troller to release it from Test Run mode to return to nor-
mal mode. (Fig. 59a)
´ µDQG´R3µZLOOGLVDSSHDUIURPWKHUHPRWHFRQ
troller clock display area.
Troubleshooting:
In the event that the green OPERATION lamp is blinking
upon powering up the system, an error condition exists. In
this case, refer to the self-diagnostics procedure on the
inside of the front cover.
After the test run is completed, be sure to press the
$&/ 5HVHWEXWWRQWRUHWXUQWRQRUPDOPRGH7KH
air conditioner will not operate correctly if this is not
done.
IMPORTANT
NOTE
Fig. 59a
Fig. 59b
Fig. 59c
1HR.
TIMER
ON/OFF
operation
ACL
(Reset)
QUIET
button
button
button
button
OPERATION lamp
TIMER lamp
QUIET lamp
 previous next