Panasonic CS-E12JKKW Air Conditioner User Manual


 
ENGLISH
9
Information for Users on Collection and Disposal of Old Equipment and used Batteries
[Information on Disposal in other Countries
outside the European Union]
These symbols are only valid in the European
Union. If you wish to discard these items,
please contact your local authorities or dealer
and ask for the correct method of disposal.
Note for the battery symbol (bottom two
symbol examples):
This symbol might be used in combination with
a chemical symbol. In this case it complies with
the requirement set by the Directive for the
chemical involved.
Pb
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
Checking of remote control batteries.
No obstruction at air inlet and air outlet vents.
After 15 minutes of operation, it is normal to have the
following temperature difference between air inlet and air
outlet vents:
Cooling: 8°C Heating: 14°C
FOR EXTENDED NON-USE
Activate Heat mode for 2~3 hours to remove moisture left
in the internal parts thoroughly to prevent mould growth.
Turn off the power supply.
Remove the remote control batteries.
SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY then please consult
authorized dealer under the following conditions:
Abnormal noise during operation.
Water/foreign particles have entered the remote control.
Water leaks from Indoor unit.
Circuit breaker switches off frequently.
Power cord becomes unnaturally warm.
Switches or buttons are not functioning properly.
Timer indicator blinks.
INFORMATION
Models Number
Single Split System
CS-E9JKKW / CU-E9JKK
CS-E12JKKW / CU-E12JKK
CS-E18JKK / CU-E18JKK
Multi Split System
CS-E12JKKW, CS-E12JKKW / CU-2E18JBK
The above listed models have been designed and manufactured to meet ENERGY STAR
®
criteria for
energy ef ciency when matched with appropriate coil components. However, proper refrigerant charge
and proper air ow are critical to achieve rated capacity and ef ciency. Installation of this product should
follow the manufacturer’s refrigerant charging and air ow instructions. Failure to con rm proper charge and
air ow may reduce energy ef ciency and shorten equipment life.