Panasonic CS-A12CKPG Air Conditioner User Manual


 
9
HELPFUL INFORMATION
Auto Operation Button
Automatic Operation
If the remote control fails to function or has been
misplaced, press the Auto Operation button to start
the Automatic operation.
The Automatic operation will be activated
immediately once the Auto operation button is
pressed. However, temperature cannot be adjusted
when in this mode.
The power indicator on the indoor unit will blink until
the operation mode is selected automatically.
To cancel this operation, press once more.
Remote Control Signal Receiving Sound
To switch off the beep (Signal Receiving Sound),
press the Auto Operation button for 10 seconds
continuously or longer.
A beep, beep sound will be heard at the
tenth seconds.
Note : A beep sound will be heard at the fifth
seconds;
However please press continuously until you
heard beep, beep sound.
Repeat the above steps if you want to switch on the
Signal Receiving Sound.
(This is for Servicing purposes only.)
Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
beep sound will be heard after five seconds
indicating the Test Run starts to operate.
POWERPOWER
TIMERTIMER
QUIETQUIETPOWERFULPOWERFUL
POWERFULPOWERFUL
ECONOMYECONOMY
ECONOMYECONOMY POWERPOWER
TIMERTIMER
QUIETQUIET
Auto Restart Control
If power is resumed after a power failure, the
operation will restart automatically after 3 - 4
minutes.
Operation will be restarted automatically under the
previous operation mode and airflow direction when
power is resumed as the operation is not stopped
by the remote control.
Timer Setting
When power failure occurs, the timer setting will be
cancelled. Once power is resumed, reset the timer.
Thunder and Lightning
This air conditioner is equipped with a built-in surge
protective device. However, in order to further
protect your air conditioner from being damaged by
abnormally strong lightning activity, you may switch
off the circuit breaker.
Raise the front panel and press.
ENERGY SAVING AND OPERATION
HINTS
Setting the Temperature
Approximately 10% of electricity can be saved.
Set the temperature higher or lower than the
desired temperature.
Cooling Model
Cooling Operation : 2°F higher
Heat Pump Model
Cooling Operation : 2°F higher
Heating Operation : 4°F lower
Air Filters
Clean the air filters every 2 weeks.
Dirty filters may reduces cooling or heating
efficiency.
Keep All Doors and Windows Closed
Otherwise, cooling or heating performance will be
reduced and electricity cost is wasted.
Outdoor Unit
Do not block the air outlet vents. Otherwise, it will
lower the cooling or heating performance.
Timer
To prevent wastage of electricity, use Timer when
going out.
Avoid Direct Sunlight
Keep curtains or drapes closed to avoid direct
sunlight during cooling operation.