Filter
Top Products
Design and specifications are subject to change without notice. 10M0205SK-HCM371-LT.X Printed in Japan
Model No.
Product type
Image data compression system
Resolution
Image quality
Frame rate*
1
Security
Encryption algorithm
IPsec function*
3
Supported protocol
User access limit
Buffered images*
4
Viewing Angle
Pan
Tilt
Revolving speed
Number of pixels
Lens focal point
Lens brightness
Required light intensity
Voice direction
Voice data compression system
Voice band
Audio input
Audio output*
5
Standards
Antenna
Number of Channel
Transmission Speed
Max. Transmission Distance
Security
Network Interface
I/O connector for sensor
SD Memory Card slot
Operating temperature
Operating humidity
Dimensions (W x H x D)
Weight
Power Supply
Consumption
BB-HCM371
Outdoor, Wireless type and voice function
JPEG (Motion JPEG for moving image display)
640 x 480, 320 x 240, 160 x 120
3 modes (Favor Clarity, Standard, Favor Motion)
Max. 30 frames/sec (320 x 240, 160 x 120), Max. 12 frames/sec (640 x 480)*
2
User ID, password, IPsec
DES-CBC, 3DES-CBC, AES-CBC
ESP encryption, EPS authentication, transport mode (main mode only)/tunnel mode
IKE (Internet Key Exchange)
IPv4/IPv6 dual stack
IPv4: TCP, UDP, IP, HTTP, FTP, SMTP, DHCP, DNS, ARP, ICMP, POP3, NTP, IPsec, UPnP
IPv6: TCP, UDP, IP, HTTP, FTP, SMTP, DNS, ICMPv6, POP3, NDP, NTP, IPsec
Max. 30 simultaneous accesses (max. 10 accesses with voice reception)
Approx. 125 images: (320 x 240), standard image quality
(approx. 16 KB per image) (without using SD Memory Card)
53° horizontal (total 173°)
40° vertical (total 105°)
–60° up to +60°
–45° up to +20°
Pan: Max. 80°/sec, Tilt: Max. 80°/sec
1/4 inch, approx. 320,000 pixels, CCD sensor
Fixed (focal range: 0.5 m to ∞)
F3.5
3 to 100,000 lx (in Color Night View mode: 0.2 to 100,000 lx)
Half-duplex two-way communication (transceiver system)
ADPCM 32 kbps
300 Hz ~ 3.4 kHz
Built-in microphone or external microphone (sold separately), external microphone input
terminal (3.5-mm dia. mini-jack)
Audio line output terminal for external speaker
(3.5-mm dia. stereo mini-jack, monaural output)
802.11 b/g
Diversity
11 ch.
up to 54 Mbps.
Indoor: About 120 m, Outdoor: About 600 m
WEP 64/128/152 bit
Ethernet (10Base-T/100Base-TX)
G GND
1 External Senser Input
G GND
2 External Senser Input
3 External Device Control Output
4 DC Power Output Terminal (10.5–13.5V DC)
Full size (operation guaranteed for 1GB, 512MB, 256MB, 128MB and 64MB SD Memory Cards)
–20°C to 50°C
20% to 90% (No condensation)
Approx. 100 x 100 x 80 mm (Only the unit)
350 g (Only the unit)
AC adaptor: Input 120V AC, Output 12V DC
10W
Specifications of BB-HCM371 Network Camera
OS
CPU
Protocol
Interface
Web browser
Audio
Microsoft
®
Windows
®
XP, Windows
®
2000,
Windows
®
Me, Windows
®
98SE
• For monitoring of image from one camera unit: Pentium RIII (800 MHz or greater)
• For monitoring of images from multiple camera units: Pentium R4 (1.8 GHz or greater)
TCP/IP (HTTP, TCP, UDP, IP, DNS, ARP,
ICMP) protocol must be installed.
10/100-Mbps LAN card must be installed.
Internet Explorer 6.0 or later
Audio input/output function (microphone, speaker, etc.)
Specifications for Compatible PC
Microsoft
®
Windows
®
XP, Service Pack 1
or later
TCP/IP (HTTP, TCP, UDP, IP, DNS, ICMPv6,
NDP) protocol must be installed.
For IPv4 For IPv6
*
1
This varies depending on the subject, image quality, network environment, PC performance, etc.
*
2
The image update speed may decrease when favor-motion mode is set, when images are recorded onto an SD Memory Card, and when IPsec is
used, as well as due to the network environment and PC performance.
*
3
Transport mode (mode for IPsec communication between terminals, for IPv4 only) operating environment: Microsoft
®
Windows
®
XP Service Pack 1
or later only, tunnel mode (mode for IPsec between VPN routers, IPv4/IPv6)
*
4
The number of images that can be stored varies depending on the subject. *
5
Install an amp or use a speaker with a built-in amp.
ServerNetwork CameraAudioTerminal WirelessGeneral
IPsec*
4
Supported
External Output Control
Pan and Tilt Movement
The Alarm-Controlled Image Transfer function uses a
commercially available external Sensor or switch and
sends the image only when there is an action such as
turning on the light or opening the door. The Timer-
Controlled Image Transfer function automatically
transmits images according to the set time zone and
the day of the week. These convenient functions
eliminate your need to constantly check the image.
IPsec is a technology used to encrypt data packets in
order to prevent eavesdropping by third parties. When
combined with a conventional authentication function
based on user names and passwords, IPsec offers
enhanced security.
This provides ON/OFF operation of an externally
connected device. For example, it can be used to turn
on a light when the surrounding area becomes dark or
to turn on a buzzer in case of an emergency.
Network CameraBB-HCM371
Pan
(173° maximum)
Tilt
(105° maximum)
Our new network cameras allow the use of a virtually
unlimited number of IP addresses*
3
by supporting
IPv6, a next-generation protocol. The IPv4/IPv6 dual-
stack feature enables you to use IPv4 at the present
and switch over to IPv6 in the future.
*
1
This logo mark is issued by the IPv6 Ready Logo Program Committee, an IPv6 promotion group established mainly by the IPv6 Forum.
*
2
This function can be used with a PC only. It cannot be used with a cell phone. To hear the voice transmitted from the PC, a commercially available
speaker with a built-in amp must be installed. The transceiver system does not allow simultaneous transmission and reception of voices.
The BB-HCM371 may require a version upgrade to operate in the IPv6 environment.
For the latest information, visit Panasonic's support Web site (http://panasonic.co.jp/pcc/products/en/netwkcam/).
*
3
An IP address is a unique number assigned to each user so that the user can be identified on the Internet.
*
4
IPsec is an IP security protocol for data encryption standardized by IETF, an international community devoted to the standardization of Internet
specifications.
IPv6-Ready
*When e-mail function is used to transfer images or messages, e-mail
transmission may not be possible in some cases due to the mail server
authentication system (SMTP authentication, etc.) used by your
Internet service provider.
*The image transfer functions can be used only with a PC. With a cell
phone, only the e-mail transmission function can be used.
Alarm-Controlled and Timer-Controlled
Image Transfer Functions
http://panasonic.co.jp/pcc/products/en/netwkcam/
Supporting Viewnetcam.com service
Viewnetcam.com service allows you to access the
camera over the Internet with your favorite domain
name (e.g. bob.viewnetcam.com) instead of a global
IP address. For more information on Viewnetcam.com
service, Please access
www.viewnetcam.com
for more information.
Multi-Camera Setup Supported
Simultaneous monitoring of images using up to four
network cameras. Images from up to four camera units
can be assigned as a group, and the monitor display can
be switched to any of three image groups. This enables
simultaneous display of the images from up to 12
camera units, with no audio.
Antenna
Audio output
terminal
Lens
Lens cover
Microphone
Indicator
*The photo shows the camera unit without the cover.
SD Memory
Card slot
RESET
button
Stand mounting section
Ethernet connector
(10/100Base-T(X))
External
microphone
input terminal
AC adaptor
connector
I/O connector Stand/tripod mounting section
Factory
Default
Button